Alto MAXIDRIVE2.3+ User Manual download pdf (Page 6)

7.ENTER Key

The key allows you to access to the selected editing . P ou can edit and confirm

value of parameter.

page ressing this key, y the required

9.INPUT LEVEL LED Meters

The LEDs are used to indicate the level of input A/B. In order to get an up-front distortion-free signal, you keep

the signal quite high, but do assure that the red CLIP LED doesn't light up continually.

10.MUTE Switches

There are four mute switches (1-4). They are used to mute the signal of the respective outputs. When the switch

is on, the corresponding LED will light up. These switches can avoid signal peaks when switching on and off the

sound system and isolate the individual audio sections during testing or checking sound, etc.. The restored Mute

function can be set to use the Wake Up Function (Utility menu Misc. Setup submenu) and can be set as Normal

(last setting before the unit was switched off) or Mute (all outputs automatically forced into Mute status).

3.2 The Rear Panel

1513

8.ESC Key

The key allows you to exit the selected editing page. It also used to reject the value to enter and return to the

stored value.

11.OUTPUT LEVEL LED Meters

These LEDs indicate the level of the respective outputs (you can adjust the output via adjusting the Output Gain

parameter of Edit menu.)

Note: The LIMITER on any output will change the way in which the level is displayed on the corresponding LED.

In fact, the level shown on the ladder is no longer the "absolute" output level, but the level of the signal at -24dB,

-12dB, -6dB compared to the limiter threshold (indicated by the orange LIMIT LED).

12.AC Inlet and Fuse Holder

13.Power Switch

The switch is used to turn the main POWER on and off. Note: before turning on the unit, please make sure the

amplifiers of the sound system are off to avoid the annoying and sometimes dangerous signal peaks.

CAUTION: If there is something wrong with the fuse or the fuse needs to change, please refer to a qualified

technician. If the fuse continues to blow after replacing, discontinue using of this unit before being repaired.

PWR

OFF

AC INPUT 14W

95-240V 50/60Hz

FUSE: 95-120V T500mAL

210-240V T315mAL

INPUT AINPUT B

OUTPUTS

Apparaten skall anslutas till

jordat uttag nar den ansluts

till ett natverk

A102

PUSH

NEW TIDE

PUSH

NEW TIDE

Use it to connect your MAXIDRIVE2.3+ to the supplied AC cord. Please check the Voltage in your country and

what voltage for your MAXIDRIVE2.3+ is configured before attempting to connect the unit for the main AC.

The fuse can protect the AC supplies circuit of the equipment.

14.OUTPUTS

These (Outputs1~4) are balanced XLR-M connectors. The high quality, low noise, 20 bit converters can make

A/D conversion.

15.INPUTS

INPUT A and INPUT B are compatible with balanced XLR and JACK. They are audio connectors of the respective

sections. The high quality, low noise, 20 bit converters can make A/D conversion.

1 2 3 4 5 6 7 8 9 10 11 ... 36 37

Comments to this Manuals

No comments

Alto MAXIDRIVE2.3+ User Manual Page 6

Comments to this Manuals

Related products and manuals for Cars Alto MAXIDRIVE2.3+