Alto Compact 110 Instruction Manual download pdf (Page 5)

2.0 Operating Instructions EN

2.1 Operating facilities

 ON/OFF switches (1).

 Trigger with lock (5a).

2.2 Connection

1. Screw the high pressure hose (5) onto the water

outlet pipe (2) by turning it clockwise

. Tighten

the hose connection by hand only. Do not use a

spanner, pliers, or the lik

e. Prior to operating the

machine please ensure that the high pressure

hose has been completely uncoiled. Whilst the

machine is in operation the hose MUST NOT

loop.

2. Check that the ﬁ lter (4a) is mounted in the water

inlet pipe (3) and that it is not clocked up.

3. The inlet ﬁ lter must always be ﬁ tted in the water

inlet pipe to ﬁ lter out sand, lime stone and other

impurities, as they will damage the pump valves.

CAUTION: Failure to ﬁ t the ﬁ lter will invalidate the

guarantee.

4. Screw the water inlet connector (4) onto the water

inlet pipe (3).

5. Make sure that the trig ger is locked in the Off

po si tion (5a) by pull ing out the lock ing le ver and

lo cat ing it on the tab in the han dle grip.

6. Mount the nozzle or any other equipment you

want to use.

7. Connect the machine to the water and power

supplies.

The pressure washer is now ready for operation.

2.3 Start

1. Check that the machine is in horizontal position.

2. Release the trig ger lock (5a) .

3. Activate the trigger and let the water run until all

air has escaped from hoses and pump.

4. Press the On/Off switch "I" (1).

2.4 Operation

1. The machine must not be operated while

hanging on the wall hook for PW (20).

2. The spray lance is affected by a thrust

during operation - therefore always hold

it ﬁ rmly with both hands. IMPORTANT:

Point the nozzle at the ground.

3. Activate the trigger of the spray handle.

4. Always adjust the distance and thus the pres-

sure of the nozzle to the surface which is to be

cleaned. NOTE: The spray angle can be adjusted

at the TORNADO

PR nozzle (7).

NOTE: Do not cover the machine during operation.

If the machine is left or not used for 5 minutes, it

must be switched off on the start/stop switch (Press

the On/Off switch "O".

2.5 End of operation

1. Press the On/Off switch "O" (1).

2. Disconnect the plug from the socket.

3. Shut off the water supply and ac ti vate the trigger

to relieve the machine of pres sure.

Concerning storage, please refer to section 5.0.

Højtryk

Lavtryk

High pressure

Low pressure

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Alto Compact 110 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Vacuum cleaners Alto Compact 110