Alto Q User Manual download pdf (Page 8)

3. CONTROL ELEMENTS

5. INSTALLATION AND CONNECTION

5.1 Mains Connection

Please ensure that the is set to the correct supply voltage before plugging

the power cord into the wall outlet, use the same fuse as marked on the fuse

holder at the AC power connection. The mains connection of the is made

by using the enclosed mains cord and a standard IEC receptacle. It meets all of

the international safety certification requirements.

LT O Q

5.2 Audio Connection

The presents with balanced XLR & 1/4" TRS It can be

interfaced in several ways to support a variety of applications without any

signal loss. The can be used on a single instrument by connecting to the

mixing console's main inserts, or on an entire mix "in-line" between a mixing console's

outputs and a power amplifier. The defective wiring may degrade the performance

of , so please use good quality screened audio cables only. Please follow

the guide below to interface without experiencing any noise or signal

loss.

LTO Q connectors.

LT O Q

Ok, you have got to this point and you are now in the position to operate your

successfully. However, we advise you to read carefully the following

section to be the real master of your own mix. Not paying attention enough to

the input signal level, to the routing of the signal and the assignment of the

signal will result in unwanted distortion, a corrupted signal or no sound at all.

So you should follow this procedure for every single channel:

LT O Q

Strain Clamp

Sleeve

Tip

Ring

Sleeve=Ground/Screen

Ring=Right Signal

Tip=Left Signal

Use for Headphone

1/4" Stereo (TRS) Jack Plug

Strain Clamp

Sleeve

Tip

Sleeve=Ground/Screen

Tip=Signal

Use for Mono Line In, Mono 1/4" Jack Plugs

1/4" Mono (TS) Jack Plug

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Alto Q User Manual Page 8

Comments to this Manuals

Related products and manuals for Musical Equipment Alto Q