Alto Q User Manual download pdf (Page 4)

Front Panel:

3. CONTROL ELEMENTS

SPOTLIGHT

3. CONTROL ELEMENTS

This control is used to set the center frequency point of the filter.

3 FREQUENCY Control

This control adjusts the width and can be set from a minimum of 0.03 octaves

to a maximum of 1.6 octaves.

4 BANDWIDT ControlH

The level boost or attenuation is set by this control. The adjusting range goes

from -15 dB to +15 dB.

5 LEVEL Control

Your LTO Q includes 5 channels of equalization, 3 rotary controls and 1 switch

are present in each channel. The Master Section includes the power switch, 2

push-on switches, 3 rotary controls and 12 LEDs.

2 IN/OUT Switch

It activates/disactivates the correspondent band.

When you set this switch to ON position (green light on), the unit will be turned

on. When you set this switch to OFF position (green light off), the unit will

be turned off.

1 POWER Switch

The input jack of your LTO Q is directly connected to the output jack when this

control is on "OUT" position or if the unit is not connected to the AC socket.

It is used to cause a "hard-bypass" and disable the equalization process in the

signal path.

6 AUDIO IN/OUT Button

AUDIO

/ OMETER

INPUT / OUTPUT LEVEL (dB)

6 30

3 6 9 12 18

50 110

25 200

40010

LOW CUT

3.5

2.5 30

KHz

OUT

OUTIN

5-BAND

PARAMETRIC

EQUALIZER

POWER

IN// OUT

KHz

OCTAVE

5.1

2.2 7.0

1.3

1.0 20

1.2

0.03 1.6

1KHz - 20KHz

FREQUENCY

BANDWIDTH LEVEL

OUT

INPUT

HIGH CUT

OFF

BAND 5

LTO Q

3 4 5 6

7 LOW CUT Control

When activate this control, it will cut the low frequencies with a slope of 12 dB

per octave in a range of 10 Hz to 400 Hz. So if you set this control at the

maximum position of 10 Hz, the audio signal will pass through without alteration.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Alto Q User Manual Page 4

Comments to this Manuals

Related products and manuals for Musical Equipment Alto Q