Alto MAC 2.4 User Manual download pdf (Page 8)

5.1 Mains Connection

Please ensure that the X23 is set to the correct supply voltage before plugging

the power cord into the wall outlet, use the same fuse as marked on the fuse

holder at the AC power connection. The mains connection of the X23 is made by

using the enclosed mains cord and a standard IEC receptacle. It meets all of the

international safety certification requirements.

5.2 Audio Connection

The X23 presents with balanced XLR & 1/4" TRS and combo connectors. It can

be interfaced in several ways to support a variety of applications without any

signal loss. The X23 can be used on a single instrument by connecting to the

mixing console's main inserts, or on an entire mix "in-line" between a mixing

console's outputs and a power amplifier. The defective wiring may degrade the

performance of X23, so please use good quality screened audio cables only.

Please follow the guide below to interface X23 without experiencing any noise

or signal loss.

Ok, you have got to this point and you are now in the position to operate your X23

successfully. However, we advise you to read carefully the following section to be

the real master of your own mix. Not paying attention enough to the input signal

level, to the routing of the signal and the assignment of the signal will result in

unwanted distortion, a corrupted signal or no sound at all. So you should follow

this procedure for every single channel:

5. INSTALLATION AND CONNECTION

Strain Clamp

Sleeve

Tip

Ring

Sleeve=Ground/Screen

Ring=Right Signal

Tip=Left Signal

Use for Headphone

1/4" Stereo (TRS) Jack Plug

Strain Clamp

Sleeve

Tip

Sleeve=Ground/Screen

Tip=Signal

Use for Mono Line In, Mono 1/4" Jack Plugs

1/4" Mono (TS) Jack Plug

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Alto MAC 2.4 User Manual Page 8