Alto MS Series User Manual download pdf (Page 106)

102 Getting Started Guide

Define the Failover Conditions Set Up High Availability

Define the Failover Conditions

Configure the Failover Triggers

Step 1 To configure link monitoring, define the

interfaces that you would like to monitor.

A change in the link state of these

interface will trigger a failover.

1. Select

Device > High Availability > Link and Path Monitoring.

2. In the Link Group section, click Add.

3. Name the Link Group, Add the interfaces to monitor, and select

the

Failure Condition for the group. The Link group you define

is added to the

Link Group section.

Step 2 (Optional) Modify the failure condition

for the Link Groups that you configured

(in the preceding step) on the device.

By default, the device will trigger a

failover when any monitored link fails.

1. Select the

Link Monitoring section.

2. Set the Failure Condition to All.

The default setting is Any.

Step 3 To configure path monitoring, define the

destination IP addresses that the firewall

should ping to verify network

connectivity.

1. In the

Path Group section of the Device > High Availability >

Link and Path Monitoring

tab, pick the option for your setup:

Add Virtual Wire Path, Add VLAN Path, Add Virtual Router

Path

2. Select the appropriate item from the drop-down list for the

Name and Add the IP addresses (source and/or destination, as

prompted) that you wish to monitor. Then select the

Failure

Condition

for the group. The path group you define is added to

the

Path Group section.

Step 4 (Optional) Modify the failure condition

for all Path Groups configured on the

device.

By default, the device will trigger a

failover when any monitored path fails.

Set the

Failure Condition to All.

The default setting is Any.

Step 5 Save your changes.

Click Commit.

1 2 ... 101 102 103 104 105 106 107 108

Comments to this Manuals

No comments

Alto MS Series User Manual Page 106

Comments to this Manuals