Alto L-12 User Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 33
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
14
- 24 BIT DIGITAL EFFECTS
Adjust this knob to select the right effect you wish
to perform. There are total 16 options for you: several
kinds of reverb, mono and stereo delay, effects with
modulation, and versatile two-effect combination.
PRESETS
33
36
DSP MUTE
VARIATIONS
STEREO GRAPHIC EQ
EQ OFF
EQ ON
AUX2
EFFECTS OUT
0
AUX1
DFX2(INT) RETURN
EFFECTS TO MONITOR
PRESETS
00
PHANTOM
PWR
-+15
8
-+15
8
-+15
8
-15
0
-10
-5
+10
+15
+5
63
500250125
2K
1K
-15
0
-10
-5
+15
+10
+5
16K
8K4K
10
8
9
1
12
11
7
4
5
6
3
2
13
14
15
16
10
8
9
1
12
11
7
4
5
6
3
2
13
14
15
16
PEAK
33 34 35 3637 38 39 40
41 42
MUTE SWITCH
35
This switch is used to activate/deactivate the effect
facility. Sometimes, you can also use the DFX FOOT
SWITCH (on rear panel) for convenient operation.
VARIATIONS
34
Since you have selected the preferable effect, the
next step, please go with the fine consideration,
there are also total 16 variations for each preset,
and each variation may be managed by several
different factors.
PEAK LED
This LED lights up when the input signal is too strong. In case of the digital effect module being muted, this LED
also lights up.
EFFECTS OUT
37
Rotate this knob to adjust the level of effect signal that intercepted from internal DSP processor and directly
sent to DFX OUT, which can be varied from - to +15dB.
DFX2(INT) RETURN EFFECTS TO MONITOR
38
POWER LED
39
The LED indicates when the Power is on in your L-12.
PHANTOM LED
40
This LED indicates when the Phantom Power is switched on.
EQ switch
41
STEREO GRAPHIC EQ
42
These AUX1 and AUX2 controls are used to set the signal level from AUX RETURN4, which signal will be sent
to AUX SEND1 and AUX SEND2. The adjustable range can be varied from - to +15dB.
Engage this button to add the stereo graphic EQ into the MAIN MIX output circuit. It can be used to modify the
frequency "contour" of a sound. If you release the button free, the stereo graphic EQ will be bypassed.
Each one of these faders will boost or attenuate (+/-15dB) the selected frequency at a preset bandwidth.
When all the sliders are in the centre position, the output of the equalizer is flat response.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 32 33

Comments to this Manuals

No comments