Alto 3.4 User Manual download pdf (Page 6)

1>. Ensure that power to the MAXIDRIVE3.4 PC and the computer is switch off.

3>. Turn on your audio system, including the MAXIDRIVE3.4 PC. Now boot up your computer and run the PC editor

(see "Configuration of the system").

2>. Connect the MAXIDRIVE3.4 PC to the PC's RS232 serial port using a data cable with 9-pin female plugs.

The required data cable is known as a 'null modern' (also data transfer) type serial interface cable. Attach the

other end to the 9-pin socket situated next to the audio output terminals of the MAXIDRIVE3.4 PC.

Note: MAXIEDITOR software, which is used in the unit , accepts these four COM1-COM4 connectors of PC

only. So when you use USB port for connecting, please operate it as follows:

Please go to control section -> system -> DEVICE MANAGER -> advance -> COM connecting number,

please

select one.

Then go to the tool bar of MAXIEDITOR -> Choose "OPTION -> USB to COM" and select the right COM.

Then it should be OK to link.

3.2 The Rear Panel

7.AC inlet and fuse holder

CAUTION: If there is something wrong with the fuse or the fuse needs to change, please refer to a qualified

technician. If the fuse continues to blow after replacing, discontinue using of this unit before being repaired.

RS485 OUT RS485 IN

INPUT AINPUT B

OUTPUTS

A102

AC INPUT 14W

95-240V 50/60Hz

FUSE: 95-120V T500mAL

210-240V T315mAL

Apparaten skall anslutas till

jordat uttag nar den ansluts

till ett natverk

PUSH

NEW TIDE

PUSH

NEW TIDE

PUSH

NEW TIDE

789

Use it to connect your MAXIDRIVE3.4 PC to the supplied AC cord. Please check the Voltage in your country and

what voltage for your MAXIDRIVE3.4 PC is configured before attempting to connect the unit for the main AC.

The fuse can protect the AC supplies circuit of the equipment.

10.OUTPUTS

These (Outputs1~6) are balanced XLR-M connectors. The high quality, low noise, 20 bit converters can make

A/D conversion.

11.INPUTS

INPUT A and INPUT B are compatible with balanced XLR and JACK. They are audio connectors of the respective

sections. The high quality, low noise, 20 bit converters can make A/D conversion.

8.RS485 OUT

9.RS485 IN

This is the standard serial communication interface. It allows outgoing communication between a MAXIDRIVE

3.4 PC and other MAXIDRIVE3.4 PC units. The RS485 interface is very suitable for remote control over long

distances (difficult with RS232 standard ports) and daisy-chaining several MAXIDRIVE3.4 PC.

The function of the RS485 IN interface is opposite to RS485 OUT. It allows incoming communication between

a MAXIDRIVE3.4 PC and other MAXIDRIVE3.4 PC units. The RS485 interface is very suitable for remote control

over long distances (Difficult with RS232 standard ports) and for daisy-chaining several MAXIDRIVE3.4 PC.

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Comments to this Manuals

No comments

Alto 3.4 User Manual Page 6

Comments to this Manuals

Related products and manuals for Cars Alto 3.4