Alto LYNX-MIX 124UM User Manual download pdf (Page 10)

Each channel is equipped with a MUTE button. Pressing this button is equal

to turning the fader down, which can mute the corresponding channel output

except for the channel INSERT send and SOLO (in PFL mode). And the MUTE

LED will illuminate.

Inside your LYNX-MIX 124UM mixer, the audio signal is treated in several different

stages and then sent to the PEAK LED. When the LED is red illuminated, it warns

you that you are reaching signal saturation and possible distortion, In order to

avoid distortion you should reduce the GAIN, EQ, or LEVEL settings.

17 PEAK LED

SPOTLIGHT

4. CONTROL ELEMENTS

18 MUTE Button & LED

19 ASSIGNMENT Controls

Each channel provides four push-buttons: SUB1-2, SUB3-4, MAIN L-R and SOLO.

Pressing the SOLO button, the corresponding SOLO LED will illuminate and the

SOLO signal will replace other signals send to the Headphone/Control Room and

Meters. Usually use the SOLO function in live work to preview channels before

they are let into the mix. It is useful to set an instrument's input level and EQ,

and you can also solo any channel that you want to. The SOLO switch never

affects any mix other than the Control Room. The other three buttons are signal

assignment switches. Pressing the SUB1-2 will assign the channel signal to

Su/jointfilesconvert/360377/bgroup1/2, using the PAN knob you can adjust the amount of channel signal

sent to the SUB1 versus SUB2, completely turning the Pan to left, the signal

will be adressed to Su/jointfilesconvert/360377/bgroup1 only and vice-versa. In the same way, pressing

the SUB3-4 or MAIN L/R will assign the channel signal to Su/jointfilesconvert/360377/bgroup3/4 or MAIN

MIX L/R, and this setting too will be affected by PAN.

20 FADER

This fader will adjust the overall level of this channel and set the amount of signal

send to SUB1-2, SUB3-4, and MAIN L-R outputs.

21 Control Room Source

You can choose to monitor any combination of MAIN MIX, SUB1-2, SUB 3-4 and

2TK IN via these Matrix switches. Engaging these switches, the stereo signals

will be delivered to the Phones, Control Room and Meters display.

NOTE: When any SOLO switch was engaged, the SOLO signal will replace other

signals, and that signal will be present to Control Room, Phones, and Meters.

22 PHONES/CTRL ROOM Controls

Rotate these knobs to independently adjust the stereo level of CTRL ROOM

and PHONES-these levels should adjusted from - to MAX.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Alto LYNX-MIX 124UM User Manual Page 10