Alto DIGAN2.30 User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 15
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
3.2 The Rear Panel
11. DIGITAL OUTPUT SPDIF
This jack is used to output the digital signal to digital record device using a standard RCA cable.
12. USB SERIAL PORT
This serial port is used to connect the unit to PC with the supplied transmission line.
13. INPUT
These are XLR and 1/4" TRS balanced connectors, which are used to connect devices such as the channel
inserts of a mixing console.
14. OUTPUT
These are XLR and 1/4" TRS balanced connectors, which are used to connect sources such as the channel
inserts of a mixing console or power amplifier's input.
15. POWER INLET
This jack is used to connect the AC power supply with the supplied 9V AC adapter.
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
Rated Power Consumption 15W
CH.B CH.A
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
OUTPUT
CH.B CH.A
INPUT
POWER
9VAC
USB
SERIAL PORT
DIGITAL OUTPUT
SPDIF
PUSHPUSH
(11)
4. INSTALLATION & CONNECTION
4.1 Mains Connection
The 9VAC adapter that meets all the international safety regulations is supplied with your LTO DIGAN2.30.
Before power on the DIGAN2.30, please make sure all connections have been made correctly and the volume
controls of the amplifier or mixer are turned down.
4.2 Audio Connection
Both XLR and 1/4 " TRS connectors are available on your LTO DIGAN2.30. In this way you can interface your
DIGAN2.30 in several different ways without experiencing any noise or signal loss. You can use your DIGAN2.30
with single instruments using the mixer's main insert or on "in-line" between a mixing console's output and a power
amplifier.
- Wiring Configuration
Either the 1/4" TRS phone jack or XLR connector can be wired in balanced and unbalanced modes, which will
be determined by the actual application status, please wire your system as the following wiring examples:
For 1/4" Phone jack
For XLR connector
XLR Type Unbalanced XLR Type alancedB
Pin3 (-)
Pin2 (+)
Pin1 ( )
(Linked to Pin1 manually, )
Pin1 ( )
Pin2 (+)
Pin3 (-)
TS Type Unbalanced
Sleeve
Tip
+
TRS Type Balanced
Tip
Ring
Sleeve
+
-
TRS Type Unbalanced
Tip
Ring
Sleeve
+
(12)(13)(14)(15)
5
SERIAL
MODEL
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Comments to this Manuals

No comments