Alto ACL2 Pro User Manual download pdf (Page 10)

THIS IS SET FOR

110V AC TO 120V

AC OPERATION

THIS IS SET FOR

220V AC TO 240V

AC OPERATION

220-240V

110-120V

220-240V

3.4 Connectors on The Rear Panel

Pic. 5 The Rear Panel of The ACL2 PRO

22. Fuse holder / Voltage electorS

This is a dual voltage unit. Before you attempt to connect and operate the unit, please make sure that your

local voltage matches the voltage on the fuse-holder cover.

Caution: The fuse protecting the AC supplies circuits of this unit. The fuse can only be changed by a qualified

technician, in the event of a fault or changing the supply voltage. If the fuse continues to blow after replacing,

discontinue use of this unit before repaired.

23 24

phone jack or XLR connector.

25. Audio Out

These connectors are used to output the signal. You can output the signal via the balanced 1/4" TRS phone jack

or XLR connector.

26. Operating Level Control

This control is used to adapt this unit to either the -10dBV home recording operating level or the +4dBu profe-

ssional studio operating level.

The Input / Output Level Meter (18) is referenced automatically to the selected level, i.e. an optimum operating

range of the meter will always be ensured.

The fuse-holder above the AC connector on the rear of the chassis has 3 triangular markers(please refer to

the above pictures), with two of these triangles opposing each other, your unit is set to the operating voltage

printed next to these markers.

To change, pull fuse-holder out and rotate 180 , then push in again.

23. AC Inlet

This connector is meant for the connection of the supplied main cord. Do not insert power cord into unit until

voltage has been correctly set. Do not plug power cord into AC power until voltage has been correctly set.

24. Audio In

These connectors are used to input the signal source. You can input the signal via the balanced 1/4" TRS

110-120V

220-240V

OPERATING LEVEL

RETURNSEND

OPERATING LEVEL

OUTPUT

INPUT

SIDECHAIN

OUTPUT

INPUT

SIDECHAIN

SLEEVE

TIP

SLEEVE

TIP

SLEEVE

TIP

SLEEVE

CHANNEL 1

CHANNEL 2

RETURN SEND

AC INPUT

95-120V /210-240V 60-50Hz95-120V /210-240V 60-50Hz

Rated Power Consumption 14W

FUSE:

210-240V: T200mAL 250VAC

95-120V: T400mAL 250VAC

REPLACE FUSE WITH CORRECT

TYPE ONLY

Apparaten skall anslutas till

jordat uttag nar den ansluts

till ett natverk

4dBu

10dBV

4dBu

10dBV

A101

TIP/PIN 2

RING/PIN 3

SLEEVE/PIN 1

TIP/PIN 2

RING/PIN 3

SLEEVE/PIN 1

TIP/PIN 2

RING/PIN 3

SLEEVE/PIN 1

TIP/PIN 2

RING/PIN 3

SLEEVE/PIN 1

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Comments to this Manuals

No comments

Alto ACL2 Pro User Manual Page 10

Comments to this Manuals

Related products and manuals for Air compressors Alto ACL2 Pro